Proface APL3000B - Node Box PC Manuale Utente Scaricare il pdf (Pagina 43)

PL3000 Series Reference Manual

2-12

 Power-ON Configuration

Specifies the PL operations at power-on. Point the cursor to [Power-ON Configuration] on the [Advanced]

menu and press the [Enter] Key to display the following screen.

Power On Delay

Specify whether to set standby time before the system starts up.

[Enabled] The system waits for 4 seconds before start-up.

[Disabled] The system starts up normally.

Restore Main Power

Specifies the operation when the main power is turned to ON. When [Power on Delay] is [Enabled], this

option is not displayed.

[Stay Off] The PL unit does not start when the reset switch is turned to ON.

It starts when the reset switch is pressed.

[Power On] The PL unit starts when the main power is turned to ON.

• If a USB device such as USB memory is connected to the PL when the PL is started, the follow-

ing phenomenon may occur, depending on the device:

• It takes about 1 minute before the OS starts up.

• The PL does not recognize the USB device.

These problems may be solved by setting [Power On Delay] to [Enable].

• Normally, specify [Power On] for use.

• When you change the setting to [Stay off], launch the OS again without turning the main power

OFF.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 140 141

Nessun commento

Proface APL3000B - Node Box PC Manuale Utente Pagina 43